Yamaha Motor Corporation RX10GTY/RX10LTGTY — Periodic maintenance and adjustment

Periodic maintenance and adjustment 9. Rotate the secondary sliding sheave clockwise and push it so that it separates from the secondary fixed sheave. 1. Secondary sliding sheave 2. Secondary fixed sheave 10. Install the V-belt between the secondary sliding and fixed sheaves. 1. V-belt position adjusting bolt 2. Spacer 1. V-belt 11. Install the drive guard, and then install the left side cover and the shroud. ESU12103 Drive chain housing To check the drive chain housing oil level 1. Place the snowmobile on a level surface and apply the parking brake. 2. Remove the shroud and the right side cover. (See page 41 for removal proce- dures.) 3.

Remove the dipstick, wipe it off with a clean rag, and then insert it back into the filler hole. 7. Tighten the V-belt position adjusting bolts. V-belt position adjusting bolt tightening torque: 10 Nm (1.0 m·kgf, 7.2 ft·lbf) 8. Install the V-belt over the primary sheave assembly. 56 V-belt position Adjustment More than 1.5 mm (0.06 in) above the edge Remove spacer From 1.5 mm (0.06 in) above the edge to 0.5 mm (0.02 in) below the edge Not necessary (It is correct.) More than 0.5 mm (0.02 in) below the edge Add spacer