Yamaha Motor Corporation RX10GTY/RX10LTGTY — Periodic maintenance and adjustment

Periodic maintenance and adjustment Recommended drive chain oil: SAE 75W or 80W API GL-3 Gear oil 5. Install the dipstick, making sure to align the notch in the dipstick handle with the projection on the drive chain housing. 4. Remove the dipstick and check that the oil is between the maximum and mini- mum level marks. If the oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the maximum level mark. NOTICE: Make sure that no foreign material enters the drive chain housing. [ECS00531] 1. Dipstick 1. Notch 2. Projection 6. Install the right side cover and the shroud. To adjust the chain tension 1. Remove the shroud and the right side cover.

(See page 41 for removal proce- dures.) 2. Loosen the locknut. 3. Turn the chain tension adjusting bolt clockwise until it is finger tight, and then loosen it 1/4 turn. 4. While holding the chain tension adjusting bolt with a wrench, tighten the locknut to the specified torque. 1. Maximum level mark 2. Minimum level mark Tightening torque: Locknut: 25 Nm (2.5 m·kgf, 18 ft·lbf) 57