Yamaha Motor Corporation RX10GTY/RX10LTGTY — Troubleshooting

Troubleshooting ESU12384 Engine turns over but does not start 1. Fuel system G No fuel supplied to combustion cham- ber No fuel in tank: Supply fuel. Clogged fuel line: Clean fuel line. Clogged injector: Ask a Yamaha dealer to inspect. 3. Compression G Insufficient Loose cylinder head nuts: Tighten nuts properly. Worn or damaged gasket: Replace gasket. Worn or damaged piston and cylin- der: Ask a Yamaha dealer to inspect. Discharged battery If the battery is discharged, the engine can be started using a fully-charged 12-volt battery and jumper cables. Two connecting leads have been provided for jump-starting the snowmobile.

Due to the rubber engine mount- ing, the snowmobile frame is not a suitable grounding point for jump-starting the engine. G Fuel supplied to combustion chamber Flooded engine: Crank engine or wipe the spark plugs dry. 2. Electrical system G Poor spark or no spark Spark plugs are dirty with carbon or are wet: Remove carbon or wipe the spark plugs dry. Replace if necessary. Faulty ignition system: Ask a Yamaha dealer to inspect. T.O.R.S. malfunction: Disconnect the throttle switch con- nectors and connect the wire har- ness connectors together to bypass the T.O.R.S. WARNING! Before by- passing the T.O.R.S., make sure that the throttle returns properly to the fully closed position. The T.O.R.S.

is an important safety de- vice; in the case of a malfunction, take the snowmobile to a Yamaha dealer immediately for repair. EWS00570 G Connect the jumper cables only to the connecting lead terminals. Do not con- nect them to the frame or any wire or other lead. WARNING G When connecting the jumper cables, do not contact the jumper cables or con- necting lead terminals to each other or to the frame or any metal part of the snowmobile. This can cause electrical system damage or A FIRE HAZARD. [EWS00561] 70