Yamaha Motor Corporation RX10GTY/RX10LTGTY — Storage

Storage ESU12433 marks. If the windshield is scratched, use a quality plastic polishing com- pound after washing. Long-term storage requires some preventive procedures to guard against deterioration. Cleaning Thoroughly clean the snowmobile, inside and out, to remove the corrosive salts and acids that can accumulate. Use Yamaha Mud, Grease, and Engine Cleaner, or an equivalent product, to loosen mud, grease, and grime. Wash with mild soap, then rinse and dry com- pletely. Lubrication Lubricate moving parts, suspension linkage, and pivot points. Use the grease or lubricant specified in the MAINTENANCE section, or Yamaha Lube-Zall general-purpose lubricant.

Proper lubrication fights corrosion while it re- duces friction. Fuel system Add Yamaha Fuel Stabilizer and Conditioner, help prevent fuel oxidation and gum and var- nish deposits, and to inhibit corrosion in the fuel system and injectors. In areas where ox- ygenated fuel (gasohol) is used, consult a Yamaha dealer. Engine Proper storage of the engine is essential to prevent costly rust and corrosion damage to internal engine components. This is more im- portant in areas where oxygenated fuel (gas- ohol) is used, because the alcohol content in the fuel increases the chance for water to en- ter the engine.

Use Yamaha Stor-Rite Engine Fogging Oil, or an equivalent fogging oil, to protect both the combustion chamber and crankshaft from corrosion. An alternate meth- od is to remove the intake silencer and squirt oil into the throttle bodies while the engine is running. NOTICE: Do not simply start the engine when in storage, starting the en- gine occasionally during the storage peri- od can cause more harm than good. Moisture and acids form during combus- tion which can actually increase the chance for corrosion damage during the storage period. [ECS00681] ECS00870 G Improper cleaning can damage plastic parts such as shroud, covers, wind- shields, headlight lenses, meter lenses, etc.

Use only a soft, clean cloth or sponge with mild detergent and water to clean plastic. G Do not use any harsh chemical products on plastic parts. Be sure to avoid using cloths or sponges which have been in contact with strong or abrasive cleaning products, solvent or thinner, fuel (gaso- line), rust removers or inhibitors, brake fluid, antifreeze or electrolyte. G Do not use high-pressure washers or steam-jet cleaners since they cause wa- ter seepage and deterioration in the fol- lowing areas: seals (of the slide rail suspension, front suspension and brakes), electric components (couplers, connectors, instruments, switches and lights), breather hoses and vents.

G For snowmobiles equipped with a wind- shield: Do not use strong cleaners or hard sponges as they will cause dulling or scratching. Some cleaning com- pounds for plastic may leave scratches on the windshield. Test the product on a small hidden part of the windshield to make sure that it does not leave any 74 NOTICE or an equivalent stabilizer, to the fuel tank to