Fuel and Air Systems/Carburetor CTM5 (20OCT92) 21-05-2 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=107 DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR IMPORTANT: To remove float, use a long nosed pliers on end of pin. Do not strike opposite end of pin. Damage to pin holder may result. Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets, float and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. IMPORTANT:
Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3. Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts: lint may plug holes or passages. 4. Inspect all parts for wear or damage, replace as necessary. NOTE: Main jet high altitude kits are available. Float is plastic. The float cannot be adjusted. Replace if necessary.
A—Seal B—Throttle Valve C—Throttle Shaft D—Choke Valve E—Pilot Jet F—Choke Shaft G—Ring H—Spring -UN-19MAR91 I—Ring J—Spring K—Screw L—Spring M—Idle Screw N—Carburetor Body M80308 O—Needle Valve P—Main Nozzle Q—Float Pin R—Drain Screw S—Spring T—Plug U—Washer V—Float Chamber W—Gasket X—Float Y—Main Jet MX,2105A1,A2 -19-21OCT92 21 05 2