Cylinder Block, Valves and Internal Components/Remove and Install Valves and Springs CTM5 (20OCT92) 21-20-2 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=117 REMOVE AND INSTALL VALVES AND SPRINGS 1. Remove carburetor. (See Group 05.) 2. Remove cylinder head. (See Group 15.) -UN-11MAR91 3. Remove tappet chamber cover/breather and gasket. IMPORTANT: Mark and keep springs and valves together. M80317 4. Compress valve spring (D) with a spring compressor (A) and move spring retainer (C) so larger hole is around valve stem. A—Spring Compressor B—Drainback Hole 5. Remove compressor, valves, spring and retainers. C—Spring Retainer D—Valve Spring 6. Inspect and analyze valves.
(See Section 100, Group 05.) 7. Inspect springs, valve guides and seats. (See this group.) 8. Check valve-to-tappet clearance. (See this group.) 9. Check that drainback hole (B) is open. 10. Align valve springs and retainers in tappet chamber. 11. Coat valve stems with oil and install in cylinder block. 12. Compress each spring and position retainer so smaller hole is around valve stem. 13. Install tappet chamber cover/breather and new gasket. 14. Install cylinder head. 15. Install carburetor. MX,2120A1,A1 -19-21OCT92 21 20 2