John Deere K Series Air-Cooled Engines — CHECK PISTON RING END GAP

Cylinder Block, Valves and Internal Components/Piston Rings CHECK PISTON RING END GAP 1. Before installing rings on piston, check end gap in cylinder bore. 2. Install each ring squarely in bore approximately 25.4 mm (1.0 in.) down from top of cylinder. M80331 -UN-11MAR91 3. Check end gap. Replace ring if end gap is more than specifications. END GAP SPECIFICATIONS Minimum End Gap . . . . . . . . . . . . . . . . . . . . . 0.18 mm (0.007 in.) Maximum End Gap Compression Rings . . . . . . . . . . . . . . . . . . . 1.00 mm (0.039 in.) Oil Ring Side Rails . . . . . . . . . . . . . . . . . . . .

1.40 mm (0.055 in.) MX,2120A1,A21 -19-21OCT92 CTM5 (20OCT92) 21-20-13 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=128 REMOVE AND INSTALL PISTON RINGS 1. Remove piston rings with a piston ring expander. 2. Inspect piston. Clean piston ring grooves. (See this group.) -UN-19MAR91 3. Check piston ring end gap. (See this group.) 4. Install top ring (A) and second ring (B) with R or NPR mark facing up. Rings should turn freely in grooves. M80329 NOTE: Install side rails with prongs (E) facing toward spacer. 5. Oil ring is an assembly. Install spacer (C), then side rails (D). Put side rail end gaps 180˚ apart.

-UN-11MAR91 A—Top Ring B—Second Ring C—Spacer D—Side Rails E—Prongs M80330 MX,2120A1,A20 -19-21OCT92 21 20 13