Cylinder Block, Valves and Internal Components/Inspect INSPECT CYLINDER BLOCK 1. Remove crankshaft. (See this group.) 2. Clean and check block for cracks. 3. Cracks not visible to the eye may be detected by coating the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil. 4. Wipe area dry and immediately apply coating of zinc oxide dissolved in wood alcohol. If crack is present, coating becomes discolored at the defective area. Replace block if any cracks are found. CTM5 (20OCT92) 21-20-17 K Series Air Cooled Engine MX,2120A1,A28 -19-21OCT92 AllTractorManuals.com 220596 PN=132 INSPECT OIL SEALS NOTE: Pack lithium base grease in new or used seals.
Flywheel side seal is located in secondary breather assembly. -UN-11MAR91 1. Remove flywheel. (See Group 10.) 2. Inspect oil seals (A and B) at flywheel end and PTO end for wear or damage. Replace if necessary. M80334 3. Remove secondary breather assembly. (See Group 05.) Flywheel Side/Breather Assembly 4. Remove crankcase cover. (See this group.) 5. Remove worn or damaged seals with a screwdriver. 6. Install seals with lip toward inside of engine using a -UN-11MAR91 bearing, bushing and seal driver set. Press seals in until flush with hub. 7. Install crankcase cover. M80335 8. Install secondary breather. PTO Side MX,2120A1,A27 -19-21OCT92 21 20 17