John Deere K Series Air-Cooled Engines — DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR

Fuel and Air Systems/Carburetor CTM5 (20OCT92) 25-05-5 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=150 IMPORTANT: To remove float, use a long nosed pliers on end of pin. Do not strike opposite end of pin. Damage to pin holder may result. Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets, float and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. IMPORTANT: Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3.

Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts: lint may plug holes or passages. 4. Inspect all parts for wear or damage, replace as necessary. NOTE: Float is plastic. The float cannot be adjusted. Replace if necessary. FG150D (Carb S.N. —840000) and FG150G shown. A—Spring M—Main Jet B—Pilot Screw N—Needle Valve -UN-06APR91 C—Idle Screw O—Float Pin D—Spring P—Gasket E—Hose Q—Float Chamber F—Clamp R—Washer G—Pilot Jet S—Plug H—Choke Shaft T—Spring M80348 I—Choke Plate U—Drain Screw J—Carburetor Body V—Float K—Throttle Shaft W—Main Nozzle L—Throttle Plate MX,2505A1,A6 -19-21OCT92 25 05 5