Group 10 Blower Housing and Flywheel REMOVE AND INSTALL FLYWHEEL 1. Remove blower housing. (See this group.) 2. Hold flywheel and remove nut and washer (A). 3. Remove starter cup (B). M80351 -UN-02APR91 4. Remove flywheel using a two-jaw puller. 5. Install flywheel. NOTE: Install washer with concave side toward flywheel. 6. Install starter cup, washer and nut. Tighten nut to 60 N·m (44 lb-ft). 7. Install blower housing. MX,2510A1,A2 -19-21OCT92 CTM5 (20OCT92) 25-10-1 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=152 REMOVE AND INSTALL BLOWER HOUSING NOTE: It is not necessary to remove recoil starter from blower housing. 1. Close fuel shutoff valve. -UN-02APR91 2.
Disconnect hose (A). 3. Cut wire tie and disconnect wiring lead (B). M80350 4. Remove blower housing (C). 5. Install blower housing. 6. Connect wiring lead. 7. Install wire tie. 8. Connect fuel hose. MX,2510A1,A1 -19-21OCT92 25 10 1