Cylinder Block, Valves and Internal Components/Piston and Connecting Rod CTM5 (20OCT92) 25-20-10 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=167 REMOVE AND INSTALL PISTON AND CONNECTING ROD 1. Remove cylinder head. (See Group 15.) 2. Remove crankcase cover. (See this group.) -UN-02APR91 3. Remove carbon and varnish from top of cylinder bore with a ridge reamer. 4. Remove cap screws (C) and connecting rod cap (B). M80370 5. Push piston and connecting rod from cylinder bore. 6. Make repairs as necessary. (See procedures in this group.) 7. Deglaze cylinder bore. (See Section 100, Group 15.) 8.
Stagger piston ring end gaps 180˚ apart, but do not align with oil ring side rail end gaps. 9. Apply a light film of oil to piston and rings. Compress rings with a ring compressor. 10. Apply a light film of oil to cylinder bore, connecting rod bearing surface and cap screws. 11. Install piston assembly in cylinder bore with engraved “L” on piston head facing flywheel side of engine. 12. Align marks (A) on connecting rod and cap. Install connecting rod cap and cap screws. Tighten cap screws to specifications. TORQUE SPECIFICATIONS Connecting Rod Cap Screws . . . . . . . . . . . . . . . 20 N·m (177 lb-in.) MX,2520A1,A15 -19-21OCT92 25 20 10