John Deere K Series Air-Cooled Engines — INSPECT CONNECTING ROD

Cylinder Block, Valves and Internal Components/Inspect Connecting Rod INSPECT CONNECTING ROD 1. Clean and inspect rod. Replace if scored. 2. Analyze crankshaft and connecting rod wear. (See Section 100, Group 10.) M80375 -UN-02APR91 3. Install connecting rod cap. Tighten to 20 N·m (177 lb-in.). 4. Measure connecting rod crankshaft bearing and piston bearing (A). Replace connecting rod if either measurement is greater than specifications. BEARING I.D. SPECIFICATIONS (MAX) Crankshaft Piston Bearing Bearing 24.55 mm 13.04 mm (0.967 in.) (0.514 in.) CTM5 (20OCT92) 25-20-13 K Series Air Cooled Engine MX,2520A1,A21 -19-21OCT92 AllTractorManuals.com 220596 PN=170 10. Measure piston O.D.

(A) perpendicular to piston pin bore. 11. Measure cylinder bore. (See Inspect Block in this group.) -UN-06APR91 12. Subtract piston O.D. measurement (A) from cylinder bore measurement to determine piston-to-cylinder bore clearance. 13. Replace piston and/or rebore cylinder block if not M80374 within specifications. (See this group.) SPECIFICATIONS Piston O.D. (A) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63.86—63.88 mm (2.516—2.5168 in.) Piston-to-Cylinder Bore Clearance (std.) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.12 mm (0.005 in.) (max.) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

0.1375 mm (0.0054 in.) MX,2520A1,A20A -19-21OCT92 25 20 13