Cylinder Block, Valves and Internal Components/Piston Rings CTM5 (20OCT92) 25-20-14 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=171 REMOVE AND INSTALL PISTON RINGS 1. Remove piston rings with a piston ring expander. 2. Inspect piston. Clean piston ring grooves. (See this group.) -UN-06APR91 3. Check piston ring end gap. (See this group.) 4. Install top ring (A) and second ring (B) with R or NPR mark facing up. Rings should turn freely in grooves. M80376 5. Oil ring is an assembly. Install spacer (C), then side rails (D). Put side rail end gaps 180˚ apart. A—Top Ring B—Second Ring C—Spacer D—Side Rails MX,2520A1,A22 -19-21OCT92 25 20 14 CHECK PISTON RING END GAP 1.
Before installing rings on piston, check end gap in cylinder bore. 2. Install each ring squarely in bore approximately 25.4 -UN-02APR91 mm (1.0 in.) down from top of cylinder. 3. Check end gap. Replace ring if end gap is more than specifications. M80377 END GAP SPECIFICATIONS Minimum End Gap . . . . . . . . . . . . . . . . . . . . . 0.18 mm (0.007 in.) Maximum End Gap . . . . . . . . . . . . . . . . . . . . . 0.80 mm (0.032 in.) MX,2520A1,A23 -19-21OCT92