John Deere K Series Air-Cooled Engines — REMOVE, INSPECT AND INSTALL CRANKSHAFT

Cylinder Block, Valves and Internal Components/Crankshaft CTM5 (20OCT92) 25-20-15 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=172 REMOVE, INSPECT AND INSTALL CRANKSHAFT 1. Remove flywheel. (See Group 10.) 2. Remove camshaft. (See this group.) -UN-02APR91 3. Remove piston and connecting rod. (See this group.) 4. Remove crankshaft. M80378 IMPORTANT: A bent crankshaft must be replaced; it cannot be straightened. FG150G Shown 5. Check crankshaft alignment (T.I.R.). (See this group.) 6. Clean and inspect crankshaft. Replace if parts are scratched or damaged. 7. Analyze crankshaft and connecting rod wear. (See Section 100, Group 10.) 8. Measure crankshaft connecting rod journal.

Replace crankshaft if measurement is less than specifications. 9. Cover keyway on flywheel end of crankshaft with tape to prevent seal damage when installing crankshaft. 10. Apply clean engine oil to crankshaft bearings and journal. 11. Pack lithium based grease in oil seals. 12. Install crankshaft. 13. Install piston and connecting rod. 14. Install crankshaft. 15. Install flywheel. JOURNAL SPECIFICATIONS (MIN) Main Bearing Journal Connecting PTO Side Flywheel Rod Journal Side 19.963 mm 19.963 mm 24.45 mm (0.786 in.) (0.786 in.) (0.963 in.) MX,2520A1,A24 -19-21OCT92 25 20 15