Cylinder Block, Valves and Internal Components/Inspect and Replace CTM5 (20OCT92) 25-20-21 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=178 8. Hone the cylinder an additional 0.028—0.030 mm (0.0011—0.0012 in.) for final bore specifications. This allows for 0.020 mm (0.0008 in.) shrinkage when cylinder cools. IMPORTANT: DO NOT use gasoline or commercial solvents to clean cylinder bores. Solvents will not remove metal particles produced during honing. 9. Clean the cylinder thoroughly using soap, warm water and clean rags. Continue to clean cylinder until white rags show no discoloration. 10. Dry the cylinder. Apply engine oil to cylinder wall.
M98,2040A,A9 -19-21OCT92 25 20 21 INSPECT AND REPLACE GOVERNOR IMPORTANT: Removal damages governor. If not damaged, do not remove. 1. Remove crankcase cover. (See this group.) -UN-07SEP88 2. Remove governor cover. 3. Inspect governor. If necessary to replace, remove with screwdriver. M51762 4. If removed, press shaft (C) back into block until it protrudes 32.2—32.8 mm (1.267—1.291 in.). NOTE: Assemble sleeve and gear before installing assembly on shaft. 5. Install sleeve (A) onto governor gear (B). 6. Install governor assembly onto shaft. Push down on assembly until it snaps into place. 7. Install governor cover. 8. Install crankcase cover. MX,2520A1,A32 -19-21OCT92