John Deere K Series Air-Cooled Engines — REBORE CYLINDER BLOCK

Cylinder Block, Valves and Internal Components/Cylinder Block CTM5 (20OCT92) 25-20-20 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=177 REBORE CYLINDER BLOCK NOTE: The cylinder block can be rebored to use 0.25, or 0.50 mm (0.010 or 0.020 in.) oversize pistons and rings. Have a reliable repair shop rebore the block, or use the drill press and honing tool. 1. Rebore cylinder with a honing tool to initial and final bore specifications. -UN-25AUG88 2. Align center of bore to press center. Set the press to operate from 200—250 rpm. 3. Lower and raise hone until ends extend 20—25 mm M24711 (0.75—1.0 in.) past ends of cylinder. 4.

Turn adjusting nut on one hone until stones contact cylinder wall at narrowest point. 5. Coat inside of cylinder with honing oil. Turn hone by hand. If you cannot turn it, hone is too tight. 6. Start drill press. Move hone up and down in cylinder approximately 20 times per minute. 7. Check cylinder diameter regularly during honing. Stop press before measuring. Remove hone from cylinder. NOTE: Finish should not be smooth, but have a 40—60˚ cross-hatch pattern. IMPORTANT: Check stone for wear or damage. Use correct stone for the job. CYLINDER INITIAL BORE SPECIFICATIONS Piston Oversize: Piston Oversize:

0.25 mm 0.50 mm (0.010 in.) (0.020 in.) 64.21—64.23 mm 64.46—64.48 mm (2.530—2.531 in.) (2.540—2.541 in.) MX,2520A1,A31 -19-21OCT92 25 20 20