Cylinder Head and Valves/Check Valve Clearance 5. Center valve seat on the valve face: —(A) shows correct position. —(B) shows incorrect. 6. Check seat for good contact using Prussian Blue Compound. M18615 -UN-07SEP88 MX,3015A1,A9 -19-21OCT92 CTM5 (20OCT92) 30-15-7 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=204 RECONDITION VALVE SEATS 1. Inspect valve seats for damage. If seats are loose, warped or distorted beyond reconditioning, replace cylinder head. Pitted or worn seats can be refaced using a seat cutter. -UN-31AUG88 2. To recondition valve seat, cut at 45˚ angle (B) to clean up seat. Cut narrowing angle (E) at 30˚.
Finish cut at 45˚ (B) to establish seating surface width (A). M51558 3. Cut valve seating surface (A) as close as possible to specifications. 4. Lap valves to seats after refacing. (See Section 100, Group 05.) SPECIFICATIONS -UN-01SEP88 A—Valve Seating Surface . . . . . . . . . . . . . . . . 0.80 mm (0.031 in.) B—Valve Seat Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45˚ C—Valve Face Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45˚ D—Valve Margin . . . . . . . . . . . . . . . . . . . . . . . 0.60 mm (0.020 in.) E—Valve Narrowing Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . 30˚ M9552 MX,3015A1,A8 -19-21OCT92 30 15 7