Cylinder Block and Internal Components/Piston and Connecting Rod REMOVE AND INSTALL PISTON AND CONNECTING ROD 1. Remove cylinder head. (See Group 15.) 2. Remove crankcase cover. (See this group.) M80177 -UN-11FEB91 3. Remove carbon and varnish from top of cylinder bore with a ridge reamer. 4. Remove cap screws (A) and connecting rod cap (B). 5. Push piston and connecting rod from cylinder bore. 6. Make repairs as necessary. (See procedures in this group.) MX,3020A1,A7 -19-21OCT92 DISASSEMBLE, INSPECT AND ASSEMBLE PISTON AND CONNECTING ROD 1. Remove circlip (C), piston pin (B) and connecting rod (A). 2. Inspect all parts for wear or damage. Replace as necessary.
(See procedures in this group.) M80178 -UN-11FEB91 3. Apply a light film of oil to piston pin and connecting rod bearing. CTM5 (20OCT92) 30-20-5 K Series Air Cooled Engine MX,3020A1,A9 -19-21OCT92 AllTractorManuals.com 220596 PN=210 7. Deglaze cylinder bore. (See Section 100, Group 15.) 8. Stagger piston ring end gaps 180˚ apart, but do not align with oil ring side rail end gaps. 9. Apply a light film of oil to piston and rings. Compress -UN-31AUG88 rings with a ring compressor. 10. Apply a light film of oil to cylinder bore, connecting rod bearing surface and cap screws. M50074 11.
Install piston assembly in cylinder bore with engraved match mark/arrow on piston head facing flywheel side of engine. 12. Install connecting rod cap and cap screws. Tighten cap screws to 12 N·m (106 lb-in.). MX,3020A1,A8 -19-21OCT92 30 20 5