John Deere K Series Air-Cooled Engines — INSPECT OIL PUMP

Cylinder Block and Internal Components/Oil Pump INSPECT OIL PUMP NOTE: Oil screen not shown. To inspect or clean screen, remove crankcase cover. (See this group.) 1. Inspect all parts for wear or damage. Replace as necessary. M52445 -UN-06DEC88 A—Check Ball D—Outer Rotor B—Relief Spring E—Gasket C—Rotor Shaft F—Cover MX,3020A1,A30 -19-21OCT92 2. Measure outside diameter of shaft. Replace both shaft and outer rotor if less than specifications. 3. Measure rotor shaft bearing. Replace crankcase cover if greater than specifications. ROTOR SHAFT SPECIFICATIONS M52446 -UN-06DEC88 M52447 -UN-06DEC88 Shaft O.D. (Min) . . . . . . . . . . . . . . . . . . . . . . . 9.01 mm (0.335 in.) Bearing I.D.

(Mix) . . . . . . . . . . . . . . . . . . . . . . 9.14 mm (0.360 in.) CTM5 (20OCT92) 30-20-16 K Series Air Cooled Engine MX,3020A1,A31 -19-21OCT92 AllTractorManuals.com 220596 PN=221 DISASSEMBLE AND ASSEMBLE OIL PUMP—IF EQUIPPED 1. Remove cover and gasket. 2. Remove oil pump assembly (A), relief spring and ball -UN-06DEC88 (B). 3. Inspect all parts. (See this group.) 4. Install oil pump assembly, gasket and cover. Tighten M52443 the cap screws using the sequence shown. -UN-06DEC88 M52444 MX,3020A1,A29 -19-21OCT92 30 20 16