Cylinder Block and Internal Components/Inspect and Replace REMOVE, INSPECT AND INSTALL OIL FILTER MANIFOLD—IF EQUIPPED 1. Remove oil filter and manifold. 2. Inspect oil filter. Replace if excessively contaminated or damaged. M80188 -UN-11FEB91 3. Inspect oil passages for clogs. Clean if needed. 4. Inspect gasket (A) for wear or damage. Replace if necessary. 5. Install filter and manifold. MX,3020A1,A35 -19-21OCT92 CTM5 (20OCT92) 30-20-18 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=223 INSPECT AND REPLACE GOVERNOR IMPORTANT: Removal damages governor. If not damaged, do not remove. 1. Remove crankcase cover. (See this group.) -UN-07SEP88 2. Inspect governor.
If necessary to replace, remove with screwdriver. 3. If removed, press shaft (C) back into block until it M51762 protrudes 32.2—32.8 mm (1.267—1.291 in.). NOTE: Assemble sleeve and gear before installing assembly on shaft. 4. Install sleeve (A) onto governor gear (B). 5. Install governor assembly onto shaft. Push down on assembly until it snaps into place. MX,3020A1,A36 -19-21OCT92 30 20 18