John Deere K Series Air-Cooled Engines — INSPECT AND REPLACE GOVERNOR SHAFT

Cylinder Block and Internal Components/Inspect and Replace INSPECT AND REPLACE GOVERNOR SHAFT NOTE: It is not necessary to remove governor shaft unless damaged. 1. Remove crankcase cover. (See this group.) M50094 -UN-31AUG88 2. Inspect shaft (A). Replace if damaged. 3. To replace shaft, loosen nut (B) on lever (C). 4. Remove retaining pin (D), governor shaft and washer (E). A—Governor Shaft B—Nut 5. Install washer, shaft and retaining pin. Tighten nut to C—Governor Lever 7 N·m (62 lb-in.). D—Retaining Pin E—Washer MX,3020A1,A37 -19-21OCT92 30 20 19 CTM5 (20OCT92) 30-20-19 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=224