John Deere K Series Air-Cooled Engines — DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR

Fuel and Air Systems/Carburetor CTM5 (20OCT92) 35-05-2 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=239 DISASSEMBLE, CLEAN, INSPECT AND ASSEMBLE CARBURETOR IMPORTANT: To remove float, use a long nosed pliers on end of pin. Do not strike opposite end of pin. Damage to pin holder may result. Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets, float and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. IMPORTANT:

Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3. Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts: lint may plug holes or passages. 4. Inspect all parts for wear or damage, replace as necessary. NOTE: Main jet high altitude kits are available.

1—Throttle Plate 2—Carburetor Body 3—Seal* 4—Felt Washer** 5—Throttle Shaft 6—Pilot Jet 7—Choke Shaft 8—Spring 9—Seal* 10—Choke Plate 11—Spring -UN-17MAY91 12—Idle Adjustment Screw 13—Spring 14—Speed Adjustment Screw 15—Washer 16—Needle Valve Seat 17—Needle Valve M80452 18—FLoat 19—Float Pin 20—Gasket 21—Float Chamber 22—Washer 23—Nut 24—Nozzle Holder 25—Main Jet 26—Bleed Pipe 27—Nozzle *Equipped on newer models only. **Equipped on older models only. MX,3505A1,A3 -19-21OCT92 35 05 2