Fuel and Air Systems/Service IMPORTANT: Do not push on float or inlet needle valve when adjusting float level. 5. Adjust float level. With carburetor upside down, support float so surface touches the needle valve. Do not compress the needle valve spring. Measure the distance from carburetor body to bottom of float surface (A). If not according to specifications, bend tang (B) to adjust float surface angle. M80453 -UN-17MAY91 FLOAT SPECIFICATIONS Distance (A) . . . . . . . . . . . . . . . . . . . . . 5—8 mm (0.200—0.310 in.) MX,3505A1,A4 -19-21OCT92 CTM5 (20OCT92) 35-05-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=240 SERVICE BREATHER 1. Remove cylinder block.
(See Group 20.) 2. Remove breather plate (B). -UN-17MAY91 3. Inspect plate for cracks or damage. Replace if necessary. 4. Make sure oil drain back hole (A) is open. M80454 5. Install breather plate. 6. Install cylinder block. MX,3505A1,A5 -19-21OCT92 35 05 3