Cylinder Block, Valves and Internal Components/Camshaft REMOVE AND INSTALL CRANKCASE COVER NOTE: Approximate crankcase oil capacity is 1.0 L (2.11 pt). 1. Drain crankcase. M80462 -UN-17MAY91 2. Disconnect governor arm return spring. 3. Remove crankcase cover and gasket. 4. Clean crankcase and crankcase cover gasket surfaces. NOTE: Install stud & bracket at position (1). 5. Install gasket and cover. Tighten cap screws using the sequence shown. 6. Connect governor arm return spring. TORQUE SPECIFICATIONS Mounting Cap Screws . . . . . . . . . . . . . . . . . . . .
21 N·m (186 lb-in.) MX,3520A1,A9 -19-21OCT92 CTM5 (20OCT92) 35-20-6 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=251 REMOVE AND INSTALL CAMSHAFT NOTE: Governor is attached to camshaft. 1. Remove crankcase cover. (See this group.) -UN-17MAY91 IMPORTANT: Align timing marks to prevent damage to tappets when removing camshaft. 2. Rotate crankshaft until timing marks (A) align. M80463 3. Remove camshaft (B). 4. Inspect camshaft. (See this group.) 5. Apply clean engine oil to camshaft lobes and journals. 6. Align timing marks and install camshaft. 7. Install crankcase cover. MX,3520A1,A10 -19-21OCT92 35 20 6