Cylinder Block, Valves and Internal Components/Camshaft INSPECT CAMSHAFT Inspect camshaft for worn or broken teeth. NOTE: Camshaft and tappets are a matched set. Replace both camshaft and tappets if necessary. M80464 -UN-17MAY91 Camshaft side journals rotate in ball bearings. Side journals are not measured. Measure lobes (A). Replace camshaft and tappets if less than specifications. SPECIFICATIONS (MIN) PTO Side Flywheel Side Cam Lobes Journal Journal 36.72 mm (1.447 in.) MX,3520A1,A11 -19-21OCT92 CTM5 (20OCT92) 35-20-7 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=252 INSPECT CAMSHAFT BALL BEARINGS 1. Remove camshaft. (See this group.) 2.
Remove bearings using a blind hole puller set. -UN-29AUG88 3. Thoroughly clean bearings in solvent. Dip bearings in light weight oil. 4. Spin the bearings by hand and check for axial (A) and radial (B) free play. M38073 5. Replace bearings if noisy or too much play. 6. Install bearings flush to inside of crankcase or crankcase cover using a bearing, bushing and seal driver set. 7. Install camshaft. MX,3520A1,A12 -19-21OCT92 35 20 7