John Deere K Series Air-Cooled Engines — ADJUST CAMSHAFT END PLAY

Cylinder Block, Valves and Internal Components/Adjust Camshaft End Play REMOVE, INSPECT AND INSTALL TAPPETS 1. Remove camshaft. (See this group.) NOTE: Mark tappets so they can be installed in their original bores during assembly. M80465 -UN-17MAY91 2. Remove tappets (A). 3. Inspect tappets for wear or damage. Replace if necessary. 4. Apply clean engine oil to tappets and bores. 5. Install tappets in original bores. 6. Install camshaft. MX,3520A1,A13 -19-21OCT92 CTM5 (20OCT92) 35-20-8 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=253 ADJUST CAMSHAFT END PLAY NOTE: Measure camshaft end play without crankcase cover gasket installed. 1.

Measure from crankcase machined surface (A) to cam -UN-31AUG88 gear timing flange (B). Record this measurement (C). 2. Measure from crankcase cover mounting face (D) to camshaft bearing inner race surface (E). Record this measurement (F). M51556 3. Subtract measurement (C) from measurement (F). Install shims having total thickness indicated on chart. A—Crankcase Machined Surface B—Camshaft Timing Flange C—Measurement D—Crankcase Cover Machined Surface E—Bearing Inner Race F—Measurement -19-14MAR89 M51557 MX,3520A1,A14 -19-21OCT92 35 20 8