Cylinder Block, Valves and Internal Components/Dynamic Balancer REMOVE, INSPECT AND INSTALL DYNAMIC BALANCER 1. Remove crankcase cover. (See this group.) 2. Rotate crankshaft until match marks (B) align. M51534 -UN-31AUG88 3. Remove dynamic balancer (A). 4. Inspect balancer for wear or damage. Replace if necessary. IMPORTANT: Align match marks exactly or balancer will not function correctly. 5. Install balancer with match marks aligned. 6. Install crankcase cover. MX,3520A1,A15 -19-21OCT92 CTM5 (20OCT92) 35-20-9 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=254 INSPECT BALANCER BALL BEARINGS 1. Remove balancer. (See this group.) 2. Remove bearings using a blind hole puller set.
-UN-29AUG88 3. Thoroughly clean bearings in solvent. Dip bearing in light weight oil. 4. Spin the bearings by hand and check for axial (A) and radial (B) free play. M38073 5. Replace the bearings if it is noisy or has too much play. 6. Install bearings flush to inside of crankcase or crankcase cover using a bearing, bushing and seal driver set. 7. Install oil seal. MX,3520A1,A16 -19-21OCT92 35 20 9