John Deere K Series Air-Cooled Engines — REMOVE AND INSTALL PISTON RINGS

Cylinder Block, Valves and Internal Components/Remove and Install Piston Rings INSPECT CONNECTING ROD 1. Clean and inspect rod. Replace if scored. 2. Analyze crankshaft and connecting rod wear. (See Section 100, Group 10.) M80472 -UN-17MAY91 3. Install connecting rod cap. Tighten to 20 N·m (177 lb-in.) 4. Measure connecting rod crankshaft bearing and piston bearing (A). Replace connecting rod if either measurement is greater than specifications. BEARING I.D.

SPECIFICATIONS (MAX) Crankshaft Piston Bearing Bearing 32.06 mm 18.04 mm (1.262 in.) (0.710 in.) MX,3520A1,A25 -19-21OCT92 CTM5 (20OCT92) 35-20-14 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=259 REMOVE AND INSTALL PISTON RINGS 1. Remove piston rings with a piston ring expander. 2. Inspect piston. Clean piston ring grooves. (See this group.) -UN-17MAY91 3. Check piston ring end gap. (See this group.) NOTE: Service rings may not be marked. If not marked, compression rings have no top side and can be M80473 installed in either direction. 4. Install top ring (A), second ring (B) and oil ring (C) with NPR mark facing up. Rings should turn freely in grooves.

MX,3520A1,A26 -19-21OCT92 35 20 14