John Deere K Series Air-Cooled Engines — REMOVE, INSPECT AND INSTALL CRANKSHAFT

Cylinder Block, Valves and Internal Components/Crankshaft CTM5 (20OCT92) 35-20-16 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=261 REMOVE, INSPECT AND INSTALL CRANKSHAFT 1. Remove camshaft. (See this group.) 2. Remove piston and connecting rod. (See this group.) -UN-17MAY91 3. Remove balancer. (See this group.) 4. Remove crankshaft. M80475 IMPORTANT: A bent crankshaft must be replaced; it cannot be straightened. 5. Check crankshaft alignment (T.I.R.). (See this group.) 6. Clean and inspect crankshaft. Replace if parts are scratched or damaged. 7. Analyze crankshaft and connecting rod wear. (See Section 100, Group 10.) NOTE: Cranksshaft rotates on ball bearings.

Crankshaft main bearing journals are not measured. 8. Measure connecting rod journal. Replace crankshaft if measurement is less than specifications. 9. Cover keyway on flywheel end of crankshaft with tape to prevent seal damage when installing crankshaft. 10. Apply clean engine oil to crankshaft bearings and journal. 11. Pack lithium based grease in oil seals. 12. Install crankshaft. 13. Install balancer. 14. Install piston and connecting rod. 15. Install camshaft. JOURNAL SPECIFICATIONS (MIN) Main Bearing Journal Connecting PTO Side Flywheel Rod Journal Side — — 31.95 mm (1.259 in.) MX,3520A1,A28 -19-21OCT92 35 20 16