Cylinder Block, Valves and Internal Components/Crankshaft INSPECT CRANKSHAFT BALL BEARINGS 1. Remove oil seals. (See Inspect Oil Seals in this group.) 2. Remove bearings using a bearing, bushing and seal driver set. M38073 -UN-29AUG88 3. Thoroughly clean bearings in solvent. Dip bearings in light weight oil. 4. Spin bearings by hand and check for axial (A) and radial (B) free play. 5. Replace bearings if noisy or too much play. 6. Install bearings flush to inside of crankcase or crankcase cover using a bearing, bushing and seal driver set. 7. Install oil seals.
MX,3520A1,A29 -19-21OCT92 CTM5 (20OCT92) 35-20-17 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=262 CHECK CRANKSHAFT ALIGNMENT (TIR) Place crankshaft into an alignment jig and rotate crankshaft slowly. Use dial indicators (A) to measure maximum total indicated runout (TIR). If not according to specification replace crankshaft. -UN-07SEP88 SPECIFICATIONS Maximum TIR . . . . . . . . . . . . . . . . . . . . . . . . . 0.05 mm (0.002 in.) M51761 MX,3520A1,A30 -19-21OCT92 35 20 17