John Deere K Series Air-Cooled Engines — INSPECT OIL SEALS

Cylinder Block, Valves and Internal Components/Inspect Oil Seals MEASURE AND ADJUST CRANKSHAFT END PLAY 1. Measure end play using dial indicator (A). 2. Move crankshaft in and out. Record this measurement. If end play is not within specifications, remove crankcase cover and add or subtract shims as necessary. M80476 -UN-17MAY91 SPECIFICATIONS End Play . . . . . . . . . . . . . . . . . . 0.05—0.20 mm (0.002—0.008 in.) MX,3520A1,A31 -19-21OCT92 CTM5 (20OCT92) 35-20-18 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=263 INSPECT OIL SEALS NOTE: Pack lithium base grease in new or used seals. 1. Remove flywheel. (See Group 10.) -UN-17MAY91 2.

Inspect oil seals (A and B) at flywheel end and PTO end for wear or damage. Replace if necessary. 3. Remove stator. (See Group 25.) M80477 4. Remove crankshaft. (See this group.) Flywheel Side 5. Remove worn or damaged seals with a screwdriver. 6. Install seals with lip to inside of engine using a bushing, bearing and seal driver set. Press in seals until flush with hub. -UN-17MAY91 7. Install crankshaft. 8. Install stator. 9. Install flywheel. M80478 PTO Side MX,3520A1,A32 -19-21OCT92 35 20 18