Cylinder Block, Valves and Internal Components/Replace Crankcase/Block Studs REMOVE AND INSTALL CYLINDER BLOCK 1. Remove crankshaft. (See this group.) 2. Remove cylinder block and gasket (A). 3. Remove breather plate. (See Group 05.) M80479 -UN-17MAY91 M51528 -UN-31AUG88 4. Inspect block. (See this group.) 5. Replace crankcase/block studs, if necessary. (See this group.) 6. Install breather plate. 7. Install new gasket and cylinder block. Tighten nuts in sequence shown to specification. 8. Install crankshaft. TORQUE SPECIFICATIONS Cylinder Block Nuts . . . . . . . . . . . . . . . . . . . . . . .
36 N·m (27 lb-ft) MX,3520A1,A33 -19-21OCT92 CTM5 (20OCT92) 35-20-19 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=264 REPLACE CRANKCASE/BLOCK STUDS 1. Remove cylinder block. (See this group.) 2. Inspect studs for cracks or wear. Replace if necessary. -UN-17MAY91 3. Install two nuts on stud and tighten together. Remove stud. 4. Put thread lock and sealer (medium strength) on M80480 threads of stud and install in block. Tighten to specification. 5. Install cylinder block. TORQUE SPECIFICATIONS Crankcase-to-Block Studs . . . . . . . . . . . . . . . . . . . 36 N·m (27 lb-ft) MX,3520A1,A34 -19-21OCT92 35 20 19