John Deere K Series Air-Cooled Engines — INSPECT CYLINDER BLOCK

Cylinder Block, Valves and Internal Components/Cylinder Block INSPECT CYLINDER BLOCK 1. Clean and check block for cracks. 2. Cracks not visible to the eye may be detected by coating the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil. 3. Wipe area dry and immediately apply coating of zinc oxide dissolved in wood alcohol. If crack is present, coating becomes discolored at the defective area. Replace block if any cracks are found. MX,3520A1,A35 -19-21OCT92 CTM5 (20OCT92) 35-20-20 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=265 NOTE: A bare block is available for service. 4.

Measure cylinder bore parallel with crankshaft and right angles to crankshaft at top and bottom of ring travel. -UN-23FEB89 5. If cylinder bore exceeds wear limit, replace cylinder block or rebore cylinder. (See this group.) NOTE: If cylinder is rebored, oversize piston and rings must be installed. M51745 CYLINDER BORE SPECIFICATIONS Standard . . . . . . . . . . . . . . . . . 79.91—79.98 mm (3.146—3.149 in.) Wear Limit . . . . . . . . . . . . . . . . . . . . . . . . . . 80.09 mm (3.155 in.) Out-of-Round (Max) . . . . . . . . . . . . . . . . . . . 0.063 mm (0.0025 in.) -UN-17MAY91 M80481 MX,3520A1,A36 -19-21OCT92 35 20 20