John Deere K Series Air-Cooled Engines — CHECK STARTER ARMATURE ROTATION

Starting Systems/Check Starter Armature Rotation TEST SOLENOID NOTE: If bench test indicated solenoid problems, use an ohmmeter or test light to check solenoid. 1. Test solenoid terminals (A and B) for continuity. There should be no continuity. M80486 -UN-17MAY91 2. Depress switch arm (C). There should be continuity when arm is fully depressed. 3. Test for open circuits between terminal (B) and tang (D). There should be continuity. 4. Test for open circuits between tang (D) and body (E). A—Terminal B—Terminal There should be continuity. C—Switch Arm D—Tang If solenoid fails any test, it is defective and must be E—Solenoid Body replaced.

MX,3530A1,A5 -19-21OCT92 CTM5 (20OCT92) 35-30-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=274 CHECK STARTER ARMATURE ROTATION 1. Remove starter. 2. Rotate armature (A). -UN-17MAY91 3. If armature does not rotate freely, armature may be bent or bearings may be worn. Disassemble and inspect starter. (See this group.) 4. Install starter. M80487 MX,3530A1,A6 -19-21OCT92 35 30 3