Starting Systems/Inspect Starter CTM5 (20OCT92) 35-30-4 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=275 INSPECT STARTER -UN-17MAY91 M80488 A—Cover G—Armature L—Bushing Q—Pinion Stopper B—Shift Lever H—Cover M—Brush R—Retaining Clip C—Spring I—Pinion N—Brush Holder S—Washer (2 used) D—Solenoid J—Brush O—Spring (2 used) T—Front Cover E—Cap K—End Cover P—Body U—Bushing F—Washer 1. Mark body and covers for correct alignment during 4. Measure brushes. Replace brushes as a set if reassembly. length of any one is less than 10 mm (0.394 in.). 2. Push pinion stopper (Q) toward pinion (I) to 5. Test starter armature and brushes. (See this remove retaining clip (R). group.) 3.
Inspect parts for wear or damage. 6. Apply a thin coat of multipurpose grease to: —sliding surfaces of armature and solenoid shift IMPORTANT: If front or rear armature bushings lever. (U,L) must be replaced, ream new —armature shaft spline. bushings to an inside diameter of —points where shaft contacts cover. 9.5 mm (+0.015, -0.00 mm). 7. Assemble starter. MX,3530A1,A7 -19-21OCT92 35 30 4