Cylinder Head and Valves/Inspect INSPECT SPRINGS Inspect spring free length. Replace if damaged or if less than specifications. FREE LENGTH SPECIFICATIONS (MIN) M50036 -UN-31AUG88 FC290V . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31.00 mm (1.220 in.) FC400V/FC420V/FC540V . . . . . . . . . . . . . . . . 37.50 mm (1.476 in.) MX,4015A1,A8 -19-21OCT92 INSPECT VALVE GUIDES Clean inside of valve guides with valve guide cleaner. Measure inside diameter of valve guides or bushings. Replace bushing if inside diameter is greater than specifications. (See this group.) M50037 -UN-31AUG88 SPECIFICATIONS (MAX) I.D. Intake and Exhaust . . . . . . . . . . . . . . . . . . . . .
7.07 mm (0.278 in.) CTM5 (20OCT92) 40-15-6 K Series Air Cooled Engine MX,4015A1,A10 -19-21OCT92 AllTractorManuals.com 220596 PN=307 INSPECT CYLINDER HEAD 1. Remove carbon deposits from combustion chamber and gasket surface using SCOTCH-BRITE abrasive pads or an equivalent. -UN-31AUG88 2. Clean head with solvent. 3. Inspect for cracks or broken cooling fins. 4. Inspect gasket surface for burrs and nicks. M50032 5. Inspect head gasket for burns and traces of gas leakage. Replace if necessary. 6. Check that oil drainback passages are not plugged. 7. Put cylinder head on a surface plate. Check for distortion at several points around the head using a feeler gauge.
Replace head if distortion is more than specifications. SPECIFICATIONS Cylinder Head Distortion (Max) . . . . . . . . . . . . . 0.05 mm (0.002 in.) MX,4015A1,A9 -19-21OCT92 40 15 6