Cylinder Head and Valves/Inspect and Replace Stem Seals CTM5 (20OCT92) 40-15-5 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=306 REMOVE AND INSTALL VALVES AND SPRINGS 1. Remove cylinder head. (See this group.) 2. Compress intake valve spring with JDM70 Valve -UN-31AUG88 Spring Compressor and remove collet halves (A). 3. Remove spring retainer (B) and spring (C). 4. Remove exhaust valve rotator with a magnet. M50033 5. Support exhaust valve from below and press down on spring retainer. 6. Remove retainer, spring and valves. 7. Inspect and replace stem seals as necessary. (See this group.) -UN-31AUG88 8. Inspect and analyze valves. (See Section 100, Group 05.) 9.
Inspect springs, valves, guides and seats. (See M50034 procedures in this group.) 10. Install valves, springs, and retainers. MX,4015A1,A6 -19-21OCT92 40 15 INSPECT AND REPLACE STEM SEALS 5 Remove valves and springs. (See this group.) IMPORTANT: Bottom spring retainer can only be removed with valve stem seal. Removal -UN-31AUG88 of retainer or seal damages stem seal. Inspect seal. If seal is not damaged, do not remove it. If necessary to replace stem seal, remove with M50111 screwdriver. MX,4015A1,A7 -19-21OCT92 INSPECT AND REPLACE STEM SEALS Remove valves and springs. (See this group.) IMPORTANT: Bottom spring retainer can only be removed with valve stem seal.
Removal -UN-31AUG88 of retainer or seal damages stem seal. Inspect seal. If seal is not damaged, do not remove it. If necessary to replace stem seal, remove with M50111 screwdriver. MX,4015A1,A7 -19-21OCT92 15 5