John Deere K Series Air-Cooled Engines — INSPECT CAMSHAFT

Cylinder Block and Internal Components/Camshaft REMOVE AND INSTALL CAMSHAFT 1. Remove crankcase cover. (See this group.) IMPORTANT: Align timing marks to prevent damage to tappets when removing camshaft. M50056 -UN-31AUG88 2. Rotate crankshaft until timing marks (A) align. 3. Remove camshaft (B). 4. Inspect camshaft. (See this group.) 5. Apply clean engine oil to camshaft lobes and journals. 6. Align timing marks and install camshaft. 7. On FC540V (S/N —014454) and FC290V engines, adjust camshaft axial play. (See this group.) 8. Install crankcase cover.

MX,4020A1,A4 -19-21OCT92 CTM5 (20OCT92) 40-20-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=314 INSPECT CAMSHAFT Inspect camshaft for worn or broken teeth. NOTE: Camshaft and tappets are a matched set. Replace both camshaft and tappets if necessary. -UN-31AUG88 Measure PTO side journal (A), flywheel side journal (B), and lobes (C). Replace camshaft and tappets if less than specifications.

M50057 SPECIFICATIONS (MIN) PTO Side Flywheel Side Cam Lobes Journal Journal FC290V 13.92 mm 15.92 mm 27.08 mm (0.548 in.) (0.627 in.) (1.066 in.) FC400V/ 20.91 mm 19.91 mm 36.75 mm FC420V (0.823 in.) (0.784 in.) (1.447 in.) FC540V 20.91 mm 20.91 mm 37.10 mm (0.823 in.) (0.823 in.) (1.461 in.) MX,4020A1,A5 -19-21OCT92 40 20 3