Cylinder Block and Internal Components/Inspect DISASSEMBLE, INSPECT AND ASSEMBLE PISTON AND CONNECTING ROD 1. Remove circlip, piston pin (A) and connecting rod (B). 2. Inspect all parts for wear or damage. Replace as necessary. (See procedures in this group.) M50063 -UN-31AUG88 3. Apply a light film of oil to piston pin and connecting rod bearing. MX,4020A1,A17 -19-21OCT92 4. Align arrow match mark (A) on piston head with MADE IN JAPAN (B) on connecting rod, or if piston is marked with R and L align the R on the piston with the Japanese characters on the connecting rod. 5. Install piston pin and circlip.
M38111 -UN-29AUG88 MX,4020A1,A18 -19-21OCT92 CTM5 (20OCT92) 40-20-12 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=323 INSPECT PISTON 1. Analyze piston and piston ring wear. (See Section 100, Group 10.) 2. Remove piston rings. (See this group.) -UN-06SEP88 IMPORTANT: Do not use a caustic cleaning solution or a wire brush to clean piston. 3. Remove all deposits from the piston. M29946 4. Clean carbon from piston ring grooves with a ring groove cleaner (A). If cleaning tool is not available, break an old ring and use it carefully to clean groove. 5. Check that oil return passages in grooves are open. MX,4020A1,A19 -19-21OCT92 40 20 12