John Deere K Series Air-Cooled Engines — CHECK PISTON RING END GAP

Cylinder Block and Internal Components/Piston Rings REMOVE AND INSTALL PISTON RINGS 1. Remove piston rings with a piston ring expander. 2. Inspect piston. Clean piston ring grooves. (See this group.) M38074 -UN-29AUG88 3. Check piston ring end gap. (See this group.) 4. Install top ring (A) and second ring (B) with R or NPR mark facing up. Rings should turn freely in grooves. 5. Oil ring is an assembly. Install spacer (C), then side rails (D). Put side rail end gaps 180˚ apart. A—Top Ring B—Second Ring C—Spacer D—Side Rails MX,4020A1,A23 -19-21OCT92 CTM5 (20OCT92) 40-20-15 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=326 CHECK PISTON RING END GAP 1.

Before installing rings on piston, check end gap in cylinder bore. 2. Install each ring squarely in bore approximately 25.4 -UN-31AUG88 mm (1.0 in.) down from top of cylinder. 3. Check end gap. Replace ring if end gap is more than specifications. M50073 END GAP SPECIFICATIONS Minimum End Gap . . . . . . . . . . . . . . . . . . . . . 0.18 mm (0.007 in.) Maximum End Gap Compression Rings FC290V . . . . . . . . . . . . . . . . . . . . . . . . . . 0.71 mm (0.028 in.) FC400V/FC420V/FC540V . . . . . . . . . . . . . . 0.90 mm (0.035 in.) Oil Ring Side Rails FC290V . . . . . . . . . . . . . . . . . . . . . . . . . . 1.20 mm (0.047 in.) FC400V/FC420V/FC540V . . . . . . . . . . . . . .

1.30 mm (0.051 in.) MX,4020A1,A24 -19-21OCT92 40 20 15