John Deere K Series Air-Cooled Engines — INSPECT CRANKSHAFT BALL BEARING

Cylinder Block and Internal Components/Crankshaft REPLACE CRANKSHAFT BEARING SHELL—FC290V 1. Remove oil seal. (See Inspect Oil Seals in this group.) 2. Drive old bearing (A) from cover using an appropriate bushing tool (B) and an arbor press. M51524 -UN-31AUG88 M51525 -UN-31AUG88 3. Align new bearing with oil grooves (C) facing out of cover and with seam (D) facing top of cover 4. Install new bearing to depth (E) 1 mm (0.039 in.) below flange surface. 5. Install new oil seal.

A—Bearing Shell B—Bushing Tool C—Oil Grooves D—Seam E—Installation Depth MX,4020A1,A27 -19-21OCT92 CTM5 (20OCT92) 40-20-18 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=329 INSPECT CRANKSHAFT BALL BEARING 1. Remove flywheel and oil seal. (See Inspect Oil Seals in this group.) 2. Remove crankshaft bearing using a bearing, bushing -UN-29AUG88 and seal driver set. 3. Thoroughly clean bearing in solvent. Dip bearing in light weight oil. M38073 4. Spin the bearing by hand and check for axial (A) and radial (B) free play. 5. Replace the bearing if it is noisy or has too much play. 6. Install bearing flush to inside of crankcase using a bearing, bushing and seal driver set. 7.

Install oil seal. MX,4020A1,A28 -19-21OCT92 40 20 18