John Deere K Series Air-Cooled Engines — ADJUST CRANKSHAFT END PLAY

Cylinder Block and Internal Components/Crankshaft CHECK CRANKSHAFT ALIGNMENT (TIR) Place crankshaft into an alignment jig and rotate crankshaft slowly. Use dial indicators (A) to measure maximum total indicated runout (TIR). If not according to specification replace crankshaft. M80432 -UN-08MAY91 SPECIFICATIONS Maximum TIR . . . . . . . . . . . . . . . . . . . . . . . . . 0.05 mm (0.002 in.) MX,4020A1,A29 -19-21OCT92 MEASURE CRANKSHAFT END PLAY 1. Measure end play using dial indicator (A). Record this measurement. 2. Move crankshaft in and out. Remove crankcase cover and adjust end play if not within specifications. (See this group.) M30048 -UN-06SEP88 SPECIFICATIONS End Play . . . . . . . .

. . . . . . . . . . 0.09—0.22 mm (0.004—0.009 in.) MX,4020A1,A30 -19-21OCT92 CTM5 (20OCT92) 40-20-19 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=330 ADJUST CRANKSHAFT END PLAY 1. With gasket (A) installed on crankcase, measure from gasket surface to crankshaft gear surface (B). Record measurement (C). -UN-31AUG88 2. Measure from crankcase cover mounting face (D) to PTO bearing end (E). Record measurement (F). A—Gasket B—Crank Gear Surface M51545 C—Measurement D—Crankcase Cover Mounting Face E—PTO Bearing End F—Measurement MX,4020A1,A31 -19-21OCT92 40 20 19