Cylinder Block and Internal Components/Inspect INSPECT OIL SEALS NOTE: Pack lithium base grease in new or used seals. 1. Remove flywheel. (See Group 10.) 2. Inspect oil seals (A and B) at flywheel end and PTO end. Replace if necessary. M38104 -UN-29AUG88 M50071 -UN-31AUG88 3. Remove crankshaft. (See this group.) 4. Remove worn or damaged seals with a screwdriver. Flywheel End 5. Install seals with lip to inside of engine using a bearing, bushing and seal driver set. Press seals in until flush with hub. On FC540V engine, press in seal on PTO side to specification, below crankcase cover flange surface. 6. Install crankshaft. SPECIFICATIONS FC540V Seal Depth . . . . . . . . . . . . . . . . . .
. . 0.50 mm (0.020 in.) PTO End MX,4020A1,A32 -19-21OCT92 CTM5 (20OCT92) 40-20-21 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=332 INSPECT CYLINDER BLOCK 1. Remove crankshaft. 2. Clean and check block for cracks. 3. Cracks not visible to the eye may be detected by coating the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil. 4. Wipe area dry and immediately apply coating of zinc oxide dissolved in wood alcohol. If crack is present, coating becomes discolored at the defective area. Replace block if any cracks are found. MX,4020A1,A33 -19-21OCT92 40 20 21