John Deere K Series Air-Cooled Engines — REBORE CYLINDER BLOCK

Cylinder Block and Internal Components/Rebore Cylinder Block CYLINDER INITIAL BORE SPECIFICATIONS Piston Oversize: Piston Oversize: Piston Oversize:

0.25 mm 0.50 mm 0.75 mm (0.010 in.) (0.020 in.) (0.030 in.) FC290V 78.21—78.23 mm 78.46—78.48 mm 78.71—78.73 mm (3.079—3.080 in.) (3.089—3.090 in.) (3.099—3.100 in.) FC400V 87.23—87.25 mm 87.48—87.50 mm 87.73—87.75 mm (3.434—3.435 in.) (3.444—3.4448 in.) (3.453—3.454 in.) FC420V 89.23—89.25 mm 89.48—89.50 mm 89.73—89.75 mm (3.513—3.514 in.) (3.523—3.524 in.) (3.533—3.534 in.) FC540V 89.21—89.23 mm 89.46—89.48 mm 89.72—89.73 mm (3.512—3.513 in.) (3.522—3.523 in.) (3.532—3.533 in.) MX,4020A1,A36 -19-21OCT92 CTM5 (20OCT92) 40-20-24 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=335 8. Hone the cylinder an additional 0.028—0.030 mm (0.0011—0.0012 in.) for final bore specifications.

This allows for 0.020 mm (0.0008 in.) shrinkage when cylinder cools. IMPORTANT: DO NOT use gasoline or commercial solvents to clean cylinder bores. Solvents will not remove metal particles produced during honing. 9. Clean the cylinder thoroughly using soap, warm water and clean rags. Continue to clean cylinder until white rags show no discoloration. 10. Dry the cylinder. Apply engine oil to cylinder wall. M98,2040A,A9 -19-21OCT92 40 20 24