Starting Systems/Inspect Electric Starter CTM5 (20OCT92) 40-30-9 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=356 INSPECT STARTER—FC290V -UN-31AUG88 M50128 A—Snap Ring E—Front Cover I—End Cover M—Brush B—Pinion Stopper F—O-Ring J—O-ring N—Brush Holder C—Spring G—Washer K—Washer O—Body D—Pinion Assembly H—Armature L—Brush Spring 1. Mark body and covers for correct alignment during 6. Measure brushes. Replace brushes as a set if reassembly. length of any one is less than 8.5 mm (0.335 in.). 2. Remove nuts and washers from terminal to remove 7. Test starter armature and brushes. (See this end cover (I). group.) 3. Push pinion stopper (B) toward pinion (D) to 8.
Apply a thin coat of multipurpose grease to: remove snap ring (A). —sliding surfaces of armature. —armature shaft spline. 4. Inspect parts for wear or damage. —points where shaft contacts cover. 5. Check magnets in body (O). Replace body if 9. Assemble starter. magnetic pull is weak. MX,4030A1,A10 -19-21OCT92 40 30 9