Starting Systems/Test Electric Starter Armature Rotation TEST SOLENOID—FC400V/FC420V/FC540V NOTE: If bench test indicated solenoid problems, use an ohmmeter or test light to check solenoid. 1. Test solenoid terminals (A and B) for continuity. There should be no continuity. M51705 -UN-31AUG88 2. Depress switch arm (C). There should be continuity when arm is fully depressed. 3. Test for open circuits between terminal (B) and tang (D). There should be continuity. 4. Test for open circuits between tang (D) and body (E). A—Terminal B—Terminal There should be continuity. C—Switch Arm D—Tang If solenoid fails any test, it is defective and must be E—Solenoid Body replaced.
MX,4030A1,A8 -19-21OCT92 CTM5 (20OCT92) 40-30-8 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=355 CHECK STARTER ARMATURE ROTATION 1. FC290V: Remove air cleaner and blower housing. (See Groups 05 and 10.) 2. Remove starter. -UN-09JAN91 3. Rotate armature (A). If armature does not rotate freely, armature may be bent or bearings may be worn. Disassemble, inspect and M80163 clean starter. (See this group.) FC290V -UN-18APR90 M53972 FC400V/FC420V/FC540V MX,4030A1,A9 -19-21OCT92 40 30 8