John Deere K Series Air-Cooled Engines — INSPECT ROCKER ARM ASSEMBLY

Cylinder Head and Valves/Rocker Arm Assembly REMOVE AND INSTALL ROCKER ARM ASSEMBLY 1. Remove rocker arm cover and gasket. 2. Turn crankshaft until piston is at highest position in compression stroke. M80405 -UN-25APR91 3. Remove e-clip (A). 4. Remove rocker shaft, washer (B) and arms (C). IMPORTANT: Mark push rods for reassembly in original locations. 5. Remove push rods. 6. Inspect parts for wear or damage. (See this group.) IMPORTANT: Align rocker arms over push rods during assembly. 7. Install push rods and rocker arm assemblies. 8. Install washer, rocker shaft and e-clip. 9. Check valve clearance. (See this group.) 10. Install rocker arm cover and gasket.

MX,4515A1,A1 -19-21OCT92 CTM5 (20OCT92) 45-15-2 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=375 INSPECT ROCKER ARM ASSEMBLY Measure outside diameter of rocker shaft and inside diameter or rocker arm bearing. Replace if not according to specifications. -UN-25APR91 -UN-25APR91 SPECIFICATIONS Minimum Shaft O.D. . . . . . . . . . . . . . . . . . . . 11.95 mm (0.470 in.) Maximum Arm I.D. . . . . . . . . . . . . . . . . . . . . 12.07 mm (0.475 in.) M80406 M80407 MX,4515A1,A2 -19-21OCT92 45 15 2