Cylinder Head and Valves/Remove and Install Inspect push rod for bend using V-blocks and a dial indicator. Turn rod slowly and read variation on indicator. Replace if variation is greater than specification. SPECIFICATION Push Rod Bend (MAX) . . . . . . . . . . . . . . . . . . 0.30 mm (0.012 in.) M50044 -UN-31AUG88 MX,4015A1,A3A -19-21OCT92 CTM5 (20OCT92) 45-15-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=376 REMOVE AND INSTALL CYLINDER HEAD ASSEMBLY 1. Remove blower housing. (See Group 10.) 2. Remove carburetor. (See Group 05.) -UN-11APR89 3. Remove rocker arm assembly. (See this group.) 4. Remove spark plug. M53065 5. Remove cylinder head assembly. 6.
Make repairs as necessary. (See procedures in this group.) 7. Install cylinder head assembly with new gasket. Install cap screws and tighten finger tight. 8. Tighten cap screws in sequence shown. Tighten to initial torque specifications. 9. Continue in sequence, 3 N·m (27 lb-in.) at a time, until final torque is as specified. 10. Install spark plug and tighten to specification. 11. Install rocker arm assembly. 12. Install carburetor. 13. Install blower housing. TORQUE SPECIFICATIONS Initial Torque . . . . . . . . . . . . . . . . . . . . . . . . . . 18 N·m (159 lb-in.) Final Torque . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 N·m (212 lb-in.) Spark Plug . . . . . . . . . . . . . .
. . . . . . . . . . . . . . 20 N·m (177 lb-in.) MX,4515A1,A3 -19-21OCT92 45 15 3