Cylinder Head and Valves/Inspect and Replace Intake Valve Stem Seal REMOVE AND INSTALL VALVES AND SPRINGS 1. Remove cylinder head. (See this group.) 2. Compress intake valve spring with JDM70 Valve Spring Compressor and remove collet halves (A). M53066 -UN-11APR89 3. Remove spring retainer (B), spring (C) and valve. 4. Inspect and replace intake valve stem seal if necessary. (See this group.) 5. Inspect and analyze valves. (See Section 100, Group 05.) 6. Inspect springs, valves, guides and seats. (See procedures in this group.) 7. Install valves, springs, retainers, and collet halves. 8. Install cylinder head.
MX,4515A1,A4 -19-21OCT92 CTM5 (20OCT92) 45-15-4 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=377 INSPECT AND REPLACE INTAKE VALVE STEM SEAL 1. Remove valves and springs. (See this group.) IMPORTANT: Bottom spring retainer (B) can only be -UN-25APR91 removed with valve stem seal. Removal of retainer or seal damages stem seal. Inspect seal. If seal is not damaged, do not remove it. M80408 2. If necessary to replace stem seal (A), remove with screwdriver. MX,4515A1,A5 -19-21OCT92 45 15 4