Cylinder Block and Internal Components/Reciprocating Balancer CTM5 (20OCT92) 45-20-5 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=386 REMOVE AND INSTALL RECIPROCATING BALANCER 1. Remove flywheel. (See Group 10.) 2. Remove camshaft. (See this group.) 3. Remove piston. (See this group.) 4. Remove support shaft (A) and O-ring (B). -UN-25APR91 5. Remove crankshaft with balancer assembly (C). 6. Make repairs as necessary. (See procedures in this group.) M80418 7. Inspect oil seals. (See this group.) 8. Cover keyway on flywheel end of crankshaft with tape to prevent damage to oil seal when installing assembly. A—Support Shaft B—O-Ring C—Balancer Assembly 9.
Put light film of oil on crankshaft bearing surfaces. D—Balancer Weight 10. Install balancer assembly with crankshaft into crankcase. 11. Align balancer weight (D) in crankcase and install support shaft and O-ring. 12. Adjust crankshaft end play. (See this group.) 13. Tighten balancer bushing assembly to 7.3 N·m (65 lb-in.). 14. Install piston. 15. Install camshaft. 16. Install flywheel. MX,4520A1,A8 -19-21OCT92 45 20 5